A 10-foot loading-bay overhang can do more than leave a noisy scrape. We often find torn seams, fresh gouges, and a roofline knocked out of square after a van catches a low deck or entryway. MPT Autobody provides commercial fleet repair in Murrells Inlet, SC, and surrounding areas, including the damage a low ceiling leaves behind. That’s why we look past the visible mark. Before any panel work begins, we trace the hit from the roof crown into the sidewalls, checking what moved, what split, and where rain could get in later.
We Find the Damage Hiding Above the Scrape
Under bright shop lights, a shallow dent can tell a different story. We check for buckled roof skin, crushed drip rails, loose trim, and door openings that no longer line up quite right. The inner structure gets a close look too, since force from an overhead strike can travel farther than the scrape suggests. For damaged upper panels, we plan roof repair around the metal, the seams, and how the body lines meet below.
- Roof crown: Stretched metal and oil-canning can reappear after a quick patch, so we check for both.
- Seams: Split sealant or a lifted edge gives rain a path underneath.
- Body alignment: We measure door and panel openings, especially if a door started binding after the hit.
Can a Van Roof Be Repaired After a Low-Clearance Strike?
Yes, in many cases. The first step is measuring the structure to separate a surface mark from deeper distortion. We inspect the van closely, then shape the repair around the damage we find instead of hiding it under filler and paint.
A roof seam or upper rear corner is easy to miss during a two-minute walk-around, and some damage only shows up once trim comes off and the panel edges are exposed. After we document the impact area, we handle straightening, rust protection, refinishing, and related body corrections.
- Inspection: We map movement across the damaged section.
- Repair work: We straighten the panel and correct the supporting points that absorbed the impact.
- Final check: Before the van leaves, we review panel fit, finish quality, and possible water-entry paths.
We Catch Warning Signs Before Water and Rust Spread
A whistle at highway speed, a damp headliner after one hard rain, or a door that suddenly needs an extra pull can point to trouble overhead. Paint cracks near the roof edge deserve attention too. Bring the van in as soon as you notice any of these, because exposed metal can rust surprisingly fast. If moisture is trapped behind a panel or seam, we find where it started rather than covering it with a fresh finish.
After an overhead strike, we show you what changed and explain the work in plain terms. At MPT Autobody, the focus stays on sound structure, clean panel fit, and a finish that holds up to daily use. Contact us at (843) 353-2659 today.